Rem Remotes: Error Codes And Diagnostic Codes - Invacare Storm4 Max Service Manual

® 4
Invacare - STORM
6.2

REM remotes: Error codes and diagnostic codes

The drive electronics can automatically rectify some faults. In this case the status display will stop
blinking. Switch the remote on and off again several times. Wait around 5 seconds each time
before switching the remote on again. If this does not rectify the fault, determine the cause using
the blink codes from the following table.
BLINK CODE
1 x blink
2 x blink
3 x blink
4 x blink
5 x blink
6 x blink
7 x blink
8 x blink
9 or 10 x blink
11 x blink
12 x blink
MAX
POSSIBLE CAUSE
Module defective
Accessory error (e.g. short-
circuit in adjusting motor)
Fault on left-hand motor
(M2). Connection
loose/defective or motor
defective
Fault on right-hand motor
(M1). Connection
loose/defective or motor
defective
Fault/brake fault on left-
hand motor (M2).
Connection loose/defective
or motor defective
Fault/brake fault on right-
hand motor (M19.
Connection loose/defective
or motor defective
Completely discharge
battery
Battery voltage too high
Faulty data transmission
between modules
Drive motors overloaded /
overheated
Compatibility problems
between modules
SOLUTION
Replace defective module
Check accessory
connections, check
accessory
Check connection plug,
check motor
Check connection plug,
check motor
Check connection plug,
check motor
Check connection plug,
check motor
Pre-charge battery
Switch lighting to low
battery voltage
Check battery charger
Remove electronic modules
except for the power
module and the remote.
Replace the modules one
after another in order to
ensure which the one was
causing the fault.
Switch remote on and off /
wait if necessary
Remove incorrect module
SERVICE MANUAL
DOCUMENTATION
See chapter 7.4.2.
See chapter 7.3.5.
See chapters 7.3.5
and 7.19.1
See chapters 7.3.5
and 7.19.1
See chapters 7.3.5
and 7.19.1
See chapters 7.3.5
and 7.19.1
See operating manual
See instruction
manual for charger
See chapter 7.4.2.
-
See chapter 7.4.2.
31