Shark Error Codes And Diagnostic Codes - Invacare Fox Service Manual

®
Invacare - Fox
6.2

Shark Error codes and diagnostic codes

The drive electronics can automatically rectify some faults. In this case the status display will stop
blinking. Switch the remote on and off again several times. Wait around 5 seconds each time
before switching the remote on again. If this does not rectify the fault, determine the cause using
the following link codes:
Blink Meaning
Code
Operating error
1
2 Battery error
Fault on left-hand
3
motor (M2)
Fault on right-hand
4
motor (M1)
Fault at left-hand
5
(M2) motor brake
6 Fault right-hand
(M1) motor brake
Error in Shark
7
remote
Error in Shark
8
power module
Communication
9
error in Shark
system
Unknown error
10
Incompatible
11
remote
Solution
Set drive lever to neutral central position
(just release drive lever) and switch on
again
Check battery and mains cable
Charge batteries.
If you switch the mobility device off for a
few minutes, the batteries can often
charge themselves up enough to enable
a short journey. You should, however,
only use this solution in emergency
situations because it results in
excessive battery discharging.
Replace batteries
Check motor cable and connecting
plug.
Check motor.
Check motor cable and connecting
plug.
Check motor.
Check cable and plug.
Check cable and plug.
Check bus cable in remote and
connecting plug.
Replace remote.
Check all the cables and plugs in the
Shark system.
Replace electronics module
Check all cables and connecting plugs
in the Shark system.
Replace remote.
Check all cables and connecting plugs.
The wrong remote has been connected.
Ensure that electronic module code and
the remote code match.
SERVICE MANUAL
Documentation
See chapter 7.6
See user manual
See chapter 7.4.1.
See chapters 7.6 and
7.11.1
See chapters 7.6 and
7.11.1
See chapter 7.6.
See chapter 7.6.
See chapter 7.6. and
7.2.2
See chapters 7.6 and
7.2.1
See chapters 7.6 and
7.2.2
See chapter 7.6.
See chapter 7.2.2 and
chapter 7.2.1.
21