Error Codes And Diagnostic Codes - Invacare Zephyr User Manual

7.8.1

Error codes and diagnostic codes

The drive electronics are capable of rectifying some errors automatically. In this case the status
display will cease to flash. Please switch the remote on and off several times. Wait approx. 5
seconds each time before switching the remote on again. If this does not rectify the error, locate
the error using the flash codes shown below.
FLASH
CODE
1 Module defective.
2 Lifter raised or
lowered too far (seat
not at driving height)
Accessory error.
3 Connection on the left
motor loose/defective
Left motor defective.
Connection on the
4
right motor
loose/defective
50
FAULT IMMEDIATE MEASURE
-
•
If lifter is raised, lower in
stages until the status
display stops flashing. If
lowered too far, raise lifter
in stages until the status
display stops flashing. If at
all possible, only drive
when the seat is at driving
height.
-
•
Check plug-in
connections.
•
Check/replace motor
•
Check plug-in
connections.
FURTHER HELP
•
Contact your dealer or
wheelchair provider
•
-
•
Contact your dealer or
wheelchair provider.
•
Contact your dealer or
wheelchair provider.
•
Contact your dealer or
wheelchair provider.
•
Contact your dealer or
wheelchair provider.