Table of Contents
Advertisement
4 Setup
4.1 General information on setup
The tasks described in this chapter are intended to be performed by trained and authorized service technicians for initial
setup. They are not intended to be performed by the user.
4.2 Adjusting the seat angle / seat height
4.2.1 Manual adjustment using perforated plates
There are three perforated plates underneath the seat for adjusting the seat angle and the seat height. These perforated
plates in connection with the adjustable rear holding plates result in a multitude of different setting possibilities.
The adjustment range of the seat height is 42.5 cm to 50 cm. The adjustment range of the seat angle is 22°. Note: The
higher the seat setting, the smaller the adjustment range of the seat angle!
•
5 mm Allen key
•
6 mm Allen key
•
13 mm wrench
•
Torque wrench
•
Thread locking adhesive such as Loctite medium-hard
The picture above shows the position of the perforated plates (1) and the holding plate fixing screws (2) for adjusting the
seat height and seat angle.
The picture above shows the front perforated plates. The procedure is similar for the rear perforated plates. A 13 mm
wrench is required in addition to a 5 mm Allen key for adjusting the front perforated plates.
1. Loosen screw (1) and remove to adjust seat height/angle.
2. Adjust perforated plate to desired height/angle.
3. Apply thread locking adhesive to screw, re-insert screw and tighten to 40 Nm.
Seat height and angle can also be adjusted using the rear holding plate.
•
Low setting = hole combination 1 and 2.
•
High setting = hole combination 1 and 3.
1. Loosen rear screw on one side (in bushing 1) so that holding plate can be swivelled up or down.
2. Loosen front screw and remove. Depending on the position, the screw is either in bushing 2 or 3.
1608312-B
Setup
9
Advertisement
Table of Contents
