Toshiba DP120F Service Manual page 533

2.6.7 Optional Paper Tray Motor
Before disassembling or reassembling, be sure to refer to "1. Before Disassembling or Reas-
sembling."
(1) Remove the optional recording paper tray block. (Refer to "2.6.1 Optional Recording Pa-
per Tray Block.")
(2) Remove the optional recording paper tray. (Refer to "2.6.2 Optional Recording Paper Tray.")
(3) Remove the optional tray left cover. (Refer to "2.6.3 Optional Tray Left Cover.")
(4) Remove the optional tray right cover. (Refer to "2.6.4 Optional Tray Right Cover.")
(5) Remove the optional tray rear cover. (Refer to "2.6.5 Optional Tray Rear Cover.")
(6) Disconnect the connector from CN3 on the optional tray PBA.
(7) Remove the two screws from the optional paper tray motor, and remove the optional
paper tray motor.
Optional paper tray motor
(8) Reassemble the components in the reverse order of disassembly.
NOTE: After reassembling, perform the print test referring to the "chapter 11: 1.5.2
PRINT TEST" on page 11-18.
March 2000 © TOSHIBA TEC
CN3
Fig. 8-2-141
8-113
Optional tray PBA
DP120F/DP125F Removal/Replacement
08-02-141