Toshiba DP120F Service Manual page 445

2.2.5 CIS
Before disassembling or reassembling, be sure to refer to "1. Before Disassembling or Reas-
sembling."
(1) Remove the CIS cover. (Refer to "2.1.3 CIS Cover.")
(2) Remove the two screws from the CIS.
(3) Lift the CIS and disconnect the connector from the CIS.
CIS
(4) Reassemble the components in the reverse order of disassembly.
NOTES: • Do not scratch or scar the glass surface. If it is dirty, wipe it with a lens
cleaning cloth.
• After reassembling, load a document and press the [COPY] key. Confirm
that copying and feeding normally operate.
If necessary, perform the control level set referring to the "Chapter 11:
1.6.4 SET CONT. LEVEL" on page 11-31.
March 2000 © TOSHIBA TEC
Connector
Fig. 8-2-34
8-25 DP120F/DP125F Removal/Replacement
08-02-34