Dedicated Transmission Parameters; Programming Procedure - Ricoh B051 Service Manual

DEDICATED TRANSMISSION PARAMETERS

4.4 DEDICATED TRANSMISSION PARAMETERS
Each Quick Dial Key and Speed Dial Code has eight bytes of programmable
parameters allocated to it. If transmissions to a particular machine often experience
problems, store that terminal's fax number as a Quick Dial or Speed Dial, and
adjust the parameters allocated to that number.
The programming procedure will be explained first. Then, the eight bytes will be
described.

4.4.1 PROGRAMMING PROCEDURE

1. Set the bit 0 of System Bit Switch 00 to 1.
2. Press "Dest. Management" in the facsimile standby mode.
3. Press "Program/Change/Delete Quick Dial".
4. Select the destination key you want to program.
5. When the programmed dial
number is displayed, press
"Start".
Make sure that the LED of
the Start button is lit as
green.
6. The settings for the switch
01 are now displayed.
Press the bit number that
you wish to change.
7. To scroll through the
parameter switches, either:
8. Select the next switch:
press "Next"
or
Select the previous switch: "Prev." until the correct switch is displayed.
Then go back to step 6.
9. After the setting is changed, press "OK".
10. After finishing, reset bit 0 of System Bit Switch 00 to 0.
B502
CÓPIA NÃO CONTROLADA
112
CÓPIA NÃO CONTROLADA
B502S104.WMF
B502S105.WMF
SM