Important Safety Notices - Ricoh B051 Service Manual



IMPORTANT SAFETY NOTICES

PREVENTION OF PHYSICAL INJURY
1. Before disassembling or assembling parts of the copier and peripherals, make sure
that the copier power cord is unplugged.
2. The wall outlet should be near the copier and easily accessible.
3. If any adjustment or operation check has to be made with exterior covers off or
open while the main switch is turned on, keep hands away from electrified or
mechanically driven components.
4. If a job has started before the copier completes the warm-up or initializing period,
keep hands away from the mechanical and electrical components because the
starts making copies as soon as the warm-up period is completed.
5.
The inside and the metal parts of the fusing unit become extremely hot while the
copier is operating. Be careful to avoid touching those components with your bare
hands.
HEALTH SAFETY CONDITIONS
Toner is non-toxic, but if you get it in your eyes by accident, it may cause temporary eye
discomfort. Try to remove with eye drops or flush with water as first aid. If unsuccessful,
get medical attention.
OBSERVANCE OF ELECTRICAL SAFETY STANDARDS
1. The copier and its peripherals must be installed and maintained by a customer
service representative who has completed the training course on those models.
2. The NVRAM on the Controller board has a lithium battery which can explode if
replaced incorrectly. Replace the NVRAM only with an identical one. Do not
recharge or burn this battery. Used NVRAM must be handled in accordance with
local regulations.
3. The danger of explosion exists if batteries on the FCU, MBU and JBIG are
incorrectly replaced. Replace only with the same or an equivalent type
recommended by the manufacturer. Discard used batteries in accordance with the
manufacturer's instructions.
SAFETY AND ECOLOGICAL NOTES FOR DISPOSAL
1. Do not incinerate toner bottles or used toner. Toner dust may ignite suddenly when
exposed to an open flame.
2. Dispose of used toner, the maintenance unit which includes developer or the
organic photoconductor in accordance with local regulations. (These are non-toxic
supplies.)
3.
Dispose of replaced parts in accordance with local regulations.
When keeping used lithium batteries in order to dispose of them later, do not put
more than 100 batteries per sealed box. Storing larger numbers or not sealing them
apart may lead to chemical reactions and heat build-up.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA