Dedicated Transmission Parameters; Programming Procedure - Ricoh Aficio 2035e Service Manual

DEDICATED TRANSMISSION PARAMETERS

2.4 DEDICATED TRANSMISSION PARAMETERS
⇒
Each Quick Dial Key has eight bytes of programmable parameters allocated to it. If
transmissions to a particular machine often experience problems, store that
terminal's fax number as a Quick Dial and adjust the parameters allocated to that
number.
The programming procedure will be explained first. Then, the eight bytes will be
described.

2.4.1 PROGRAMMING PROCEDURE

⇒
1. Set the bit 0 of System Bit Switch 00 to 1.
2. Press User Tools> System Settings> Key Operator Tools> Address Book
Management.
3. Select the destination where you want to change the settings.
4. Press "Fax Dest."
5. When the programmed dial number is displayed, press "Start". Make sure that
the LED of the Start button is lit as green.
6. The settings for the switch 00 are now displayed. Press the bit number that you
wish to change.
7. To scroll through the parameter switches:
Select the next switch: press "Next"
-or-
Select the previous switch: "Prev." until the correct switch is displayed.
Then go back to step 6.
8. After the setting is changed, press "OK".
9. After finishing, reset bit 0 of System Bit Switch 00 to 0.
B653 76
Rev. 01/2005
SM