Ricoh B051 Service Manual page 224

SERVICE PROGRAM MODE
Mode No.
3
(Class 1, 2, and 3)
910* Doctor Interval
1 Color
2 Black
3 Job end
920* Lubrication Cleaning Time
1 Lubrication Cleaning
Time
921* Lubricant time
1 Job end
2 Doctor roller reverse
operation
922 Lubricant Brush Off
1 1 Color
2 2 Color/3 Color/4 Color
NOTE: Requires BICU
Firmware version
1.253:01 and controller
version 2.01.5.
B051/B052
CÓPIA NÃO CONTROLADA
If the number of pages in a job exceeds this number, the
doctor roller rotates in reverse at the end of the job.
[0 ~ 50 / 50 / 1 sheet/step]
The value indicates how many sheets are output before
the doctor roller is reversed. (Sheet counts are
converted into equivalent A4-LEF sheet counts.)
The roller is reversed for 16 seconds
Reversing the roller removes toner blockages.
The sheet count is reset after reverse rotation.
The machine waits until the end of the job before
reversing the doctor roller.
Decrease the value when vertical white lines appear on
prints.
[0 ~ 65535 / 50 / 1 sheet/step]
If at the end of a job, the roller has not been reversed
since more than this number of pages, the roller is
reversed at the end of the job.
[0 ~ 65535 / 20 / 1 sheet/step]
Sets the OPC belt lubrication period. DFU
[0 ~ 100 / 50 / 1%/step]
When 100 is specified, the OPC belt cleaning clutch is
always on whenever the OPC is turning, so the OPC
gets lubricated. When 50 is specified, the clutch is only
on half the time that the motor is on.
NOTE: Requires BICU Firmware version 1.253:01 and
controller version 2.01.5.
Specifies the duration of lubrication at the end of jobs.
[0 ~ 30 / 20 / 1 /step] DFU
Specifies the duration of lubrication during reverse
doctor roller rotation.
[0 ~ 30 / 20 / 1 /step] DFU
Allows the image transfer belt cleaning clutch off timing
to be adjusted. The setting determines the number of
seconds after image transfer belt cleaning roller charging
that the clutch is turned off. With previous versions, the
clutch is always running while the development roller
motor rotates. [0 ~ 11 / 6 / 1s /step]
5-26
CÓPIA NÃO CONTROLADA
Function / [ Setting ]
Rev. 04/2004
Rev. 06/2003
SM