Dedicated Transmission Parameters; Programming Procedure - Ricoh B202 Service Manual

Hide thumbs Also See for B202:

Table of Contents

4.4 DEDICATED TRANSMISSION PARAMETERS

Each Quick Dial Key and Speed Dial Code has eight bytes of programmable

parameters allocated to it. If transmissions to a particular machine often experience

problems, store that terminal's fax number as a Quick Dial or Speed Dial, and

adjust the parameters allocated to that number.

The programming procedure will be explained first. Then, the eight bytes will be

1. Set the bit 0 of System Bit Switch 00 to 1.

2. Press "Dest. Management" in the facsimile standby mode.

3. Press "Program/Change/Delete Quick Dial".

4. Select the destination key you want to program.

5. When the programmed dial

number is displayed, press

Make sure that the LED of

the Start button is lit as

6. The settings for the switch

01 are now displayed.

Press the bit number that

you wish to change.

7. To scroll through the

parameter switches, either:

8. Select the next switch:

press "Next"

Select the previous switch: "Prev." until the correct switch is displayed.

Then go back to step 6.

9. After the setting is changed, press "OK".

10. After finishing, reset bit 0 of System Bit Switch 00 to 0.

DEDICATED TRANSMISSION PARAMETERS

B712S104.WMF

B712S105.WMF

Table of Contents