Media eject motor assembly removal
1.
Remove the rear upper cover. See
2.
Remove the media eject clutch. See
3.
Disconnect the connector from the media eject motor assembly (A).
4.
Disconnect the connector from the sensor (media bin level 2) (B).
5.
Remove the three screws securing the media eject motor assembly (A).
6.
Remove the media eject motor assembly (A).
7.
Remove any remaining harnesses from the clamps.
"Rear upper cover removal" on page
"Media eject clutch assembly removal" on page
A
Connector
7500-XXX
4-101.
4-154.
Rear
Repair information
4-155