Media Eject Shaft Assembly Removal - Lexmark X850e Service Manual

Media eject shaft assembly removal

1.
Remove the finisher front door assembly. See
2.
Remove the rear upper cover. See
3.
Move the slip clutch gear 24T (A) toward the rear as shown to disengage the stacker bin (B).
4.
Move the stacker bin down as shown to its lowest position after it is disengaged.
Note: Make sure the stacker bin is at its lowest position before continuing.
5.
Remove the upper media bin assembly. See
6.
Remove the four screws securing the right panel (C) to the finisher.
C
7.
Remove the media eject motor assembly. See
8.
Release the hook of the media eject shaft gear 39T (D) from the media eject shaft assembly (E).
9.
Remove the media eject shaft gear 39T (D).
10.
Remove the 6 mm bushing (F).
11.
Use a prying tool to remove the e-clip securing the media eject shaft assembly (E) to the rear of the
finisher.
12.
Remove the 8 mm bushing (G).
13.
Remove the two e-clips securing the media eject shaft assembly (E) to the front of the finisher.
14.
Remove the 6 mm bushing (F) and the 8 mm bushing (G).
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
B
"Media eject motor assembly removal" on page
4-101.
A
Rear
Repair information
7500-XXX
4-104.
4-97.
4-155.
4-151