Sensor (Bridge Unit Media Entrance) Removal - Lexmark X850e Service Manual

Sensor (bridge unit media entrance) removal

1.
Remove the bridge unit assembly. See
2.
Place the bridge unit assembly upside down.
3.
Remove the screw securing the bracket (A) to the bridge unit assembly (B).
4.
Disconnect the connector from the sensor (bridge unit media entrance) (C).
5.
Release the hooks securing the sensor (bridge unit media entrance) (C) to the bracket (A).
6.
Remove the sensor (bridge unit media entrance) (C).
"Bridge unit assembly removal" on page
C
4-81.
A
B
Connector
Repair information
7500-XXX
4-93