Lexmark X850e Service Manual page 89

Step Check
5 Check the sensor (tray 4 pre-feed) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor Test.
4. Touch Tray 4.
5. Touch Pre-feed.
Remove the media tray assembly.
Does the operator panel display change every time a
white piece of paper is placed over the sensing area of
the above sensor?
6 Check the tray 4 pre-feed sensor for proper connection.
Is the above sensor connected properly?
7 Check the 2TM/TTM controller card assembly and the
printer engine card assembly for proper connection.
Are connectors P541 and P413 on the above cards
connected properly?
8 Check the tray 4 media feed lift motor for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor Tests.
4. Touch Tray 4 feed mtr.
Does the above media feed lift motor operate properly?
9 Check the tray 4 media feed lift motor for proper
connection.
Is the above media feed lift motor connected properly?
10 Check the tray 4 media feed lift motor for proper
operation.
Replace the media feed lift motor for tray 4 with that for
tray 3.
Does the replaced media feed lift motor operate
properly?
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor Tests.
4. Touch Tray 4 feed mtr.
Does the above media feed lift motor operate properly?
11 Check the 2TM/TTM controller card assembly and the
printer engine card assembly for proper connection.
Are connectors P541 and P413 on the above cards
connected properly?
Yes No
Ensure the Feed unit Go to step 6.
front guide is
properly installed.
Go to step 7.
Replace the sensor Replace the
(pre-feed). connection.
"2X 500-
Go to
sheet drawer
(2TM)–sensor
(pre-feed) removal"
on page 4-25.
Go to step 10. Replace the
connection.
Go to step 11. Go to step 9.
Go to step 10. Replace the
connection.
Reinstall the media Go to step 11.
feed lift motor for
tray 3 as it
previously was, and
then replace the
media feed lift motor
for tray 4 with a new
one.
"2X 500-
Go to
sheet drawer
(2TM)–media feed
lift motor removal"
on page 4-17.
Go to step 12. Replace the
connection.
Diagnostic information
7500-XXX
2-21