Sensor (Compiler Media In) Static Jam - Lexmark X850e Service Manual

Step Check
6 Check the sensor (compiler media in) connection.
Are the connections of the compiler unit cable
assembly properly connected?
7 Perform a print test. Does the error still occur?

286.00 Sensor (compiler media in) static jam

Step Check
1 Check the media eject clamp motor for proper
operation.
Remove the rear upper cover. Go to
cover removal" on page
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Tests.
4. Touch Media eject clamp mtr.
Does the media eject clamp motor operate properly?
2 Check the media eject clamp motor connection.
Are the connections of the main drive cable assembly
properly connected?
3 Check the sensor (compiler media in) for proper
operation.
Perform the sensor (compiler media in) test.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 1.
5. Touch Compiler media in.
Insert sheet of media into the compiler unit assembly.
Does the operator panel display change every time the
compiler media in actuator of the sensor (compiler
media in) is operated?
"Rear upper
4-101.
Yes No
Replace the Replace the
sensor (compiler connection.
media in).
Go to "Sensor
(compiler media
in) removal" on
page 4-150.
Replace the Problem solved
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-195.
Yes No
Go to step 3. Go to step 2.
Replace the Replace the
media eject connector.
clamp motor.
"Media
Go to
eject clamp
motor assembly
removal" on
page 4-143.
Go to step 5. Go to step 4.
Diagnostic information
7500-XXX
2-93