Finisher Eject Set Jam - Lexmark X850e Service Manual

7500-XXX

285.00 Finisher eject set jam

Step Check
1 Check the media path.
Check the media eject shaft by turning it with your
fingers.
Is the media eject shaft assembly installed properly,
meaning does it rotate smoothly?
2 Check the media eject clamp motor for proper
operation.
Remove the rear upper cover. Go to
cover removal" on page
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Tests.
4. Touch Media eject clamp mtr.
Does the media eject clamp motor operate properly?
3 Check the media eject motor connection.
Is the above motor connected properly?
4 Check the compiler media in actuator for proper
operation.
Is the actuator operating properly?
5 Check the sensor (compiler media in) for proper
operation.
Perform the sensor (compiler media in) test.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 1.
5. Touch Compiler media in.
Insert sheet of media into the compiler unit assembly.
Does the operator panel display change every time the
compiler media in actuator of the sensor (compiler
media in) is operated?
2-92
Options Service Manual
"Rear upper
4-101.
Yes No
Go to step 2. Clean or replace
the media eject
shaft assembly
and clean the
media path.
Go to step 4. Go to step 3.
Disconnect then Replace the
reconnect the connection.
connector P8304
on the finisher
controller card
assembly.
Perform a print
test, if the error
still occurs
replace the
media eject
motor assembly.
Go to step 5. Reinstall the
compiler media in
actuator.
Go to
(compiler media
in) removal" on
page
Go to step 7. Go to step 6.
"Sensor
4-150.