Sensor (Media Eject Clamp Hp) Removal - Lexmark X850e Service Manual

7500-XXX
Replacement note: When replacing the bracket, turn the media eject clamp gear 70T (F) so that it interacts with
the sensor (media eject clamp HP).

Sensor (media eject clamp HP) removal

1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
Remove the two media eject unit springs attached to the media eject unit assembly by pushing them
downward.
4.
Remove the media eject clamp motor assembly. See
page 4-143.
5.
Release the hooks of the sensor (media eject clamp HP) (A) from the bracket (B).
6.
Remove the sensor (media eject clamp HP) (A).
4-144
Options Service Manual
"Rear upper cover removal" on page
Right
Springs
B
A
B
"Upper media bin assembly removal" on page
"Media eject clamp motor assembly removal" on
4-101.
4-97.