NEC Univerge SV8100 Features And Specifications Manual page 173

UNIVERGE SV8100
Program
Program Name
Number
44-05-09 ARS/F-Route Table – Maximum
Digit
44-05-10 ARS/F-Route – CCIS over IP
Destination Point Code
44-05-11 ARS/F-Route – Network
Specified Parameter Table
51-01-01 NetLink System Property Setting
– NetLink System ID
51-03-01 NetLink Internet Protocol
Address List Setting – Internet
Protocol Address List
Operation
To place a call using ARS:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
You hear normal Intercom dial tone.

2. Dial 9.
You hear a second, "stutter" dial tone.

3. Dial the outside number.
If you hear another "stutter" dial tone, you must enter your extension ARS Authorization Code.

Automatic Route Selection
Description/Comments
Set the maximum number of digits
to send when using the F-Route.
For each ARS/F-Route table
(1~500). Set the CCIS over IP
Destination Point Code (0~16367).
For each ARS/F-Route table
(1~500) assign the priority (1~4).
Assign the Network Specified
Parameter Table (0~16).
This is the ID of each NetLink
system. Set to insure that no
overlap occurs between nodes.
The system seeks the Primary
system based on this list.
When there is no Primary system
yet, or Fail Over occurs, Node List
is referred to establish new link.
This setting is necessary when
Program 51-01-03 is 0, or
Program 51-05-02 is other than 0.
Once the system connects to the
Primary System, this setting is
updated by the Primary system
when Program 51-13-01 is On.
So, enter IP address of the
systems which may become
Primary at least.
Assigned Data
1
0~24

(default = 0)
0~16367

(default = 0)
0~16

(default = 0)
0~50

(0 = No operation)
(default = 0)
0.0.0.0~
126.255.255.254
128.0.0.1~
191.255.255.254
192.0.0.1~
223.255.255.254
(default = 0.0.0.0)

Issue 13.0
Level
2 3
2 - 139