NEC Univerge SV8100 Features And Specifications Manual page 826

Issue 13.0
Program
Program Name
Number
10-46-06 DT700 Server Information Setup
– Register Mode
10-46-13 DT700 Server Information Setup
– Subscribe Session Port
10-46-14 DT700 Server Information Setup
– NAT Mode
10-58-01 Network Address – Network
Address
2 - 792
Description/Comments
Assign the port number in which
the SIP messages are sent on the
IPLA/IPLB. This same port
number must be assigned in the
SIP multiline terminals. If this
command is changed, it requires a
CPU reset.
Assign the port number to be used
for subscription messages
between the SV8100 and the
DT700 terminals.
Turns On/Off the DT700 NAT
mode of the system.
This program sets the IP or
Network address for phones that
are not to be routed through the
NAPT translations.
For example, if a system had
multiple NAPT phones and
another site, with multiple IP
phones connected via a VPN
connection, you would not want
the phones connected over the
VPN to use the NAPT feature.
The network address (or single IP
phone addresses) of the Remote
location would be entered here.
This is for the IP Phones at this
location to not use the NAPT
feature.
UNIVERGE SV8100
Assigned Data
1
0~65535
(default = 5080)
0~65535
(default = 5081)
0 = Off

1 = On
(default = 0)
0.0.0.0~
126.255.255.254
128.0.0.1~
191.254.255.254
192.0.0.1~
223.255.255.254
(default = 0.0.0.0)
IP Multiline Station (SIP)
Level
2 3


