Isdn 2 B-Channel Transfer - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

Calling Party Name is dependant upon the carrier. The network carrier must allow the

SV8100 to edit the Calling Party Name information.

SV8100 does not support ISDN sub-addressing.

SV8100 does not support ISDN Network Specific Parameters for the AT&T protocol such

as SDN (Software Defined Network, also known as Virtual Private Network), Megacom,

and Megacom800.

ISDN 2 B-Channel Transfer

This ISDN PRI 2 B-Channel Transfer feature allows the UNIVERGE SV8100 to receive a call on one

B-Channel and transfer it back out on a second B-Channel (Trunk-to-Trunk transfer on the telco side).

When the transferred call connects, both of the B-Channels are then released and available for either

making or receiving another call. This feature provides more efficient use of B Channels on an ISDN

PRI by allowing a customer to transfer calls without tying up their B Channels for the duration of the call.

This feature is available with Version 4000 (4.01 or higher) CPU software.

The bearer capability of two calls must be "Speech, 3.1-kHz Audio, Unrestricted Digital

Information" or compatible.

This feature is not supported with Automatic Transfer.

This feature is not supported with Unsupervised Conference.

This feature is only supported with a Manual Transfer.

This feature is only supported when both trunks are ISDN/PRI and the bearer capability of

the two trunks meet the same service requirements.

Trunk-to-Trunk programming must be enabled for this feature to work.

Both ISDN/PRI trunks must reside in the same system for this feature to work.

This feature is available if the Telco Service Provider supports this feature.

This feature is available in the following case:

At least one call to be transferred is:

answered (outgoing from the SV8100)

answered (incoming to the SV8100)

ISDN Compatibility