NEC Univerge SV8100 Features And Specifications Manual page 726

Issue 13.0
Program
Program Name
Number
10-05-01 General Purpose Relay Setup –
Slot No. Physical Port of DLCA
Sensor Circuit No.
10-05-02 General Purpose Relay Setup –
Drive Timer Setup
10-21-05 CD-CP00-US Hardware Setup –
General Purpose Relay Switch
on CD-CP00-US
10-21-06 CD-CP00-US Hardware Setup –
Drive Timer Setup on CD-CP00-
US
11-12-50 Service Code Setup (for Service
Access) – General Purpose
Relay
2 - 692
Description/Comments
Define which relay circuits (5~8)
on the PGD(2)-U10 ADP are used
for General Purpose Relays.
A maximum of (8) general purpose
relay can be assigned using
PGD's. Relay Circuits 5~8 can be
assigned on multiple PGD's.
Ex. PGD 1 has relay circuits 5~8
assigned to system Relay 1~4.
PGD 2 can have relay circuits 5~8
assigned to system Relay 5~8.
With Version 7000 or higher
software, the drive timer controls
how long the relay is in a closed
state before automatically
changing back to an open state.
Used to enable/disable the
General Purpose Relay that is
built into the CD-CP00-US.
With Version 7000 or higher
software, the drive timer controls
how long the relay is in a closed
state before automatically
changing back to an open state.
This is the access code to enable/
disable the General Purpose
relays.
After dialing the service code the
user must then dial the relay (0~8)
to enable/disable the relays.
0 = Relay on CD-CP00
1~8 = Relay assigned on PGD
UNIVERGE SV8100
Assigned Data
1
Slot No: 0~24
DCLA Port: 0~16
Relay No: 0, 5~8
 After each entry,
press Transfer to
advance to the next

entry.
(default = 0 - 0 - 0)
0–64800
0 = No drive timer
1 = 0.1 seconds
2 = 0.2 seconds
3 = 0.3 seconds
.
.
64800 = 6480
(seconds)
(default = 0)
0 = Off
1 = Relay 1 on CPU
2 = Relay 2 on CPU
(default = 0)
0–64800
0 = No drive timer
1 = 0.1 seconds
2 = 0.2 seconds
3 = 0.3 seconds
.
.
64800 = 6480
(seconds)
(default = 0)
MLT, SLT
(default = 780)
General Purpose Relay
Level
2 3



