NEC Univerge SV8100 Features And Specifications Manual page 168

Issue 13.0
Recognize Extension Location when Logging In with Netlink:
Program
Program Name
Number
26-01-01 Automatic Route Selection
Service – ARS Service
26-01-03 Automatic Route Selection
Service – ARS Misdialed Number
Handling
26-01-06 Automatic Route Selection
Service – Class of Service Match
Access
26-01-08 Automatic Route Selection
Service – DT700 Multi Log-on
for ARS
2 - 134
Description/Comments
Enable/Disable ARS.
If a user dials a number not
programmed in ARS, determine if
the system should Route over
trunk group 1 (0) or Play error tone
(1).
With the ARS Class of Service
Match Access feature, you can
determine whether or not the
system should allow a call based
on the COS assigned to the Dial
Analysis Table (Program 26-02).
This change can be used to create
a tenant-like application. It then
uses the trunk group set in the
Additional Entry in Program
26-02-03 to place the out-going
call. When this feature is enabled,
the calls are routed in sequential
order, and forward – provided the
Class of Service for the trunk
groups match.
Enable or Disable Recognize
Extension Location when logging
in with NetLink
UNIVERGE SV8100
Assigned Data
1
0 = Disable (Off)

1 = Enable (On)
(default = 0)
0 = Route to Trunk
Group 1
1 = Play Warning Tone
to Dialer
(default = 0)
0 = Disable (Off)
1 = Enable (On)
(default = 0)

0 = Disable (Off)

1 = Enable (On)
(default = 0)
Automatic Route Selection
Level
2 3
