NEC NEAX 2000 IPS Installation Manual page 44

Application Processor Card Name and Function
EQUIPMENT FUNCTIONAL
NAME
PN-SC03-B CSH
PN-SC03-C CSH
PZ-M537 EXPMEM
PZ-M542 CONN
PZ-M557 CONN
[For
Australia]
NAME
CS (ZT) Handler Card for S-interface/U-interface
Provides the D-channel signaling interface and controls maximum
four CSI cards, eight CS (ZT)s.
Supports number extension of PS.
[Series 3400 software required]
CS (ZT) Handler Card for S-interface/U-interface
Provides the D-channel signaling interface and controls maximum
four CSI cards, eight CS (ZT)s.
Supports number extension of PS.
Memory Expansion Card for AP00 Card
The system capacity is expanded when PZ-M537 is mounted on
PN-AP00-B (AP00) card.
This card is not required for PN-AP00-D (AP00) card.
Memory Expansion for AP00 is shown in the table below.
Coaxial Cable Connection Card
Used to connect a coaxial cable for the Digital Trunk Interface.
Maximum two cards can be connected to LTC connector of each
PIM.
Coaxial Cable Connection Card
Used to connect a coaxial cable for the Digital Trunk Interface.
Maximum two cards can be connected to LTC connector of each
PIM.
CHAPTER 1 GENERAL INFORMATION
FUNCTION
– 28 –
EQUIPMENT NAME AND FUNCTION
NWA-008841-001 Rev.5.0
90ch1001.fm
JULY/1/2006