NEC NEAX 2000 IPS Installation Manual page 324

PZ-M606-A (ETHER)
Switch Settings
This card has no switches.
Mounting PZ-M606-A Card
When mounting the ETHER card on the MP card, do the following procedure.
STEP1: Take off four screws from the rear side of ETHER support.
NOTE: Supports and screws are attached to the ETHER card.
STEP2: Connect the CONN connector on the ETHER card and the CONN connector on the MP card.
STEP3: Secure the ETHER card to the MP card with four screws which have been taken off by STEP1.
Mounting ETHER Card on MP card
Support
ETHER Card
CONN Connector of ETHER Card
ETHER Card
MP Card
CONN Connector on MP Card
– 308 –
NWA-008841-001 Rev.5.0
90ch3002.fm
OCTOBER/31/2005