NEC NEAX 2000 IPS Installation Manual page 247

<Hold/Start/Release Swap>
This item specifies the locations of Hold, Start, and Release key.
STEP1: Display Configuration Menu P3.
STEP2: Press the numeric key 3 (HOLD/START/RELEASE SWAP).
STEP3: Press the desired numeric key. An asterisk (*) shows the selected number.
1. Original setting
2. Swapped setting
NOTE: The locations of each key changes as shown below.
STEP4: Press the SRC key. The display returns to Configuration Menu.
STEP5: Press the Answer key to update the configuration data.
When canceling update, press the Release key.
When specifying other item, press the DEST key.
When returning previous item, press the SRC key.
[CONFIG MENU P3] VER x
1: REC VOLUME
2: BLF
3: HOLD/START/RELEASE SWAP Answer: update
[HOLD/START/RELEASE SWAP] SRC: menu
* 1: ORIGINAL
2: SWAPPED
NOTE
ORIGINAL SETTING
Hold
Start
Release
[CONFIG MENU P3] VER x
1: REC VOLUME
2: BLF
3: HOLD/START/RELEASE SWAP Answer: update
Page 221
SRC: prev page
DEST: next page
Release: exit
SWAPPED SETTING
Release
SRC: prev page
DEST: next page
Release: exit
– 231 –
SN716 DESKCON (DLC)
Default setting:
"1:ORIGINAL"
Start
Hold
Page 225
NWA-008841-001 Rev.5.0
90ch2002.fm