NOTE
To recall a paper size from a size key ([S1] to [S5]), it is necessary to register a
paper size in that key beforehand. For instructions on registering a paper size, see
Chapter 4, "Customizing Settings," in the Reference Guide.
❑
Press [Next].
❑
Select the desired paper type ➞ press [OK].
If you want to adjust the thickness of the toner applied to the paper, press
[Plain Ppr Print Set.]. If too much toner is being applied to the paper, press
[Thin]. If not enough toner is being applied to the paper, press [Heavy].
If the desired paper type is not displayed, press [Detailed Settings] ➞ select
the paper type from the list ➞ press [OK].
If you are printing onto the back side of a previously printed sheet, press [2nd
Side of 2-Sided Page].
IMPORTANT
If you select a nonstandard size paper, the Rotate Collate, Rotate Group, Offset
Collate, Offset Group, Staple, Hole Punch, 2-Sided Printing, Booklet, Cover/Sheet
Insertion, or Cover/Job Separator mode cannot be specified.
● To print on an envelope loaded in the stack bypass:
❑
Press [Stack Bypass].
If you want to select the stack bypass when a paper size/type is already
selected for current or reserved job, press [Stack Bypass Settings] to specify
the desired paper size/type.
❑
Press [Envelope].
❑
Select the desired envelope type ➞ press [OK].
IMPORTANT
•
If the envelope type is not set correctly, a paper jam will occur.
•
If you use envelopes that have glue attached to their flaps, the glue may melt due to
the heat and pressure of the fixing unit.
•
If you select [Envelope], the Finishing, 2-Sided Printing, Cover/Sheet Insertion,
Cover/Job Separator, Booklet, or Form Composition mode cannot be specified.
❑
Press [OK].
3
Press [Done].
4
Press [Start Print].
2-29
Paper Selection
2