● To designate an area with multiple points:
❑
Press [Multi-point] ➞ specify the area with the edit pen.
❑
After designating the last point, press [Fix Multipoints].
You can designate up to 10 points.
IMPORTANT
•
If you select [Multi-point], only one area can be designated at a time.
•
An area that is designated by selecting [Multi-point], cannot be modified using
(numeric keys).
5
Select [Framing] or [Blanking].
Details of each item are shown below.
[Framing]:
Copy only the contents of the designated area while discarding
the rest of the original.
[Blanking]:
Copy the original by blanking out the contents of the designated
area.
If you want to use different settings for different areas, select the area by pressing
the appropriate area key ➞ select [Framing] or [Blanking].
6
Press [Preview] ➞ check the designated area ➞ press [Done].
NOTE
•
If the designated area is rectangular, and you want to continue designating other
areas, repeat steps 4 to 6. Areas that have already been designated are displayed
with the new area.
•
To modify a designated area that was specified using the edit pen, press [Area Fine
Adj.] ➞ [Point select] until the screen displays the desired point that you want to
modify ➞ press [
[Preview] to check the modified area.
] to move the point ➞ press [Done] ➞
], [
], [
], or [
Using Image Creation Modes
4
-
4-65