Canon Color imageRUNNER C3480 Manual page 238

4
6
4-60
Using Image Creation Modes
❑
Designate the area using the edit pen.
Mark the two opposing points with the edit pen.
NOTE
•
To clear the first point entered, press [Erase Point]. (Once an area is designated,
[Erase Point] changes to [Clear Area].)
•
To clear a designated area, press [Clear Area].
To zoom in on any area on the original, press the ratio drop-down list ➞ select an
•
enlargement ratio ➞ press [ ], [ ], [ ], or [ ] to specify the area to display.
•
To check the designated area, press [Preview].
•
To modify a designated area that was specified by using the edit pen, press [Area
Fine Adj.] ➞ [Point select] ➞ select the point that you want to modify ➞ press [
] to move the point ➞ press [Done] ➞ [Preview] to check the
[ ], [ ], or [
modified area.
❑
Press [OK].
● Using the numeric keys:
❑
Press [Numeric Key Entry].
IMPORTANT
•
Before performing the next step, you must manually measure the size and position
of the area that you want to designate on the original.
•
When you measure the XY values, always start measuring from the image out to
the right side edge of the original, and up to the top of the original. These
measurements tell the machine the desired framed area's size and position.
❑
Press [X1], [X2], [Y1], and [Y2] ➞ use
respective measurements ➞ press [OK].
[X1]: The distance of the area's right border to the original's right edge.
[X2]: The distance of the area's left border to the original's right edge.
[Y1]: The distance of the area's top border to the original's top edge.
[Y2]: The distance of the area's bottom border to the original's top edge.
NOTE
To change a value you entered, press [X1], [X2], [Y1], or [Y2] ➞ enter the correct
•
value using - (numeric keys).
•
To check the designated area, press [Check Area].
•
To clear all your entries, press [Clear Area].
To specify the amount of the space between repeated images,
press [Margin Settings].
If you do not specify [Margin Settings], proceed to step 8.
- (numeric keys) to specify the
],