Ricoh D025 Service Manual page 610

System Service Mode
High Temp. Correction
004 Specifies the temperature correction for the heating roller. When the high
temperature condition (specified with SP1112-002) is detected, the value of
this SP is subtracted from the heating roller temperature.
Low Temp. Correction: Paper
005
Feed
High Temp. Correction: Paper
006
Feed
1113 [Stand-by Time]
001 After Ready
After Recovery
003
Specifies the time for keeping the target temperature after recovery
(SP1105-083) without any jobs.
004 After Job
005 PressureTemp: After Ready
006 Pressure Temp: After Job
008 ON/OFF Time Switch
D023/D025
*ENG [0 to 15 / 5 / 1 deg/step]
*ENG [0 to 15 / 6.5 / 0.1 deg/step]
*ENG
[0 to 15 / 5 / 1 deg/step]
*ENG [0 to 60 / 20 / 1 sec/step]
*ENG
[0 to 60 / 10 / 1 sec/step]
*ENG [0 to 60 / 10 / 1 sec/step]
*ENG
[0 to 160 / 100 / 1 deg/step]
*ENG
*ENG [0 to 999 / 300 / 1 sec/step]
8-14 SM Appendix