Ricoh D025 Service Manual page 602

System Service Mode
Pressure Temp: Paper Feed: MT:
008
BW
009 Pressure Temp: Paper Feed: MT: FC *ENG
010 Fusing Upper Limit Tem
011 Offset: Feed Start
012 Offset: Feed Start: Middle Thick
031 Offset: Feed Start: F
032 Feed: Glossy: Ready : U limit
033 Offset: Feed Start: Glossy
040 1bin: Paper Feed: Pressure Temp
041 F :1bin: Paper Feed: Pressure Temp *ENG
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp.
001
Specifies the heating roller target temperature for the ready condition.
Fusing Ready: Offset
002 Sets the heating roller offset temperature for the printing ready condition.
Ready temperature = (Target temperature specified in SP1-105-1) –
Temperature specified in this SP mode
D023/D025
*ENG
*ENG
[0 to 100 / 15/ 1 deg/step]
*ENG [0 to 100 / 25/ 1 deg/step]
*ENG [0 to 100 / 10/ 1 deg/step]
*ENG
*ENG
*ENG
*ENG [0 to 100 / 85 / 1 deg/step]
[0 to 100 / 75 / 1 deg/step]
*ENG [145 to 155 / 145 / 1 deg/step]
*ENG [15 to 30 / 15 / 1 deg/step]
8-6 SM Appendix