Field Service Ver. 1.0 Mar. 2005
16.6.81
C9401: Exposure Lamp's failure to turn ON
16.6.82
C9402: Exposure Lamp turning ON at abnormal timing
Scanner Assy
Flat Cable
Step
Check the flat cable for proper connection and
1
correct or change as necessary.
2
Change Scanner Assy.
3
Change PWB-C.
16.6.83
CA051: Standard Controller configuration failure
MFP Control Board (PWB-MFPC)
Step
Check to see if the following setting has been
correctly made: "Service Mode" → "System 2" →
1
"Image Controller Setting."
If the setting is changed, be sure to turn OFF and
ON the Main Power Switch.
Check the connectors of the MFP Control Board
2
(PWB-MFPC) for proper connection and correct
as necessary.
3
Change PWB-MFPC.
16.6.84
CC001: Vendor connection failure
Control Board (PWB-MC)
Step
Check the Vendor connector for proper connec-
1
tion and correct as necessary.
Check the PWB-MC connector for proper con-
2
nection and correct as necessary.
3
Change PWB-MC
Relevant Electrical Parts
Image Processing Board (PWB-C)
Action
Relevant Electrical Parts
Action
Relevant Electrical Parts
Coin Vendor (Japan)
Coin Vendor Kit (North America, Europe)
Action
16. Malfunction code
WIRING DIAGRAM
Control Signal
(Electrical
Component)
—
—
—
WIRING DIAGRAM
Control Signal
(Electrical
Component)
—
—
—
WIRING DIAGRAM
Control Signal
(Electrical
Component)
—
—
—
Location
—
—
—
Location
—
—
—
Location
—
—
—
365