Konica Minolta bizhub C450 Service Manual page 211

8. Utility Mode
(5) Image Stabilization
<Image Stabilization Only>
Functions • The image stabilization sequence is carried out without clearing the historical data of
image stabilization control.
Use • Use if an image problem persists even after Gradation Adjustment has been exe-
cuted.
• When D Max Density and Background Voltage Margin of Service mode are changed.
Adjustment 1. Call the Administrator Setting to the screen.
2. Touch "System Setting" → "Expert Adjustment" → "Image Stabilization" → "Image
Procedure
Stabilization Only."
3. Press the Start key to start Stabilizer.
The Start key turns orange and stays lit up orange during the Stabilizer sequence.
4. Stabilizer is completed when the Start key turns green.
<Initialize+Image Stabilization>
Functions • To carry out an image stabilization sequence after the historical data of image stabili-
zation control has been initialized.
Use • Use if an image problem persists even after Gradation Adjustment has been exe-
cuted.
• Use if tone reproduction and maximum density are faulty even after Image Stabiliza-
tion has been executed.
Adjustment 1. Call the Administrator Setting to the screen.
2. Touch "System Setting" → "Expert Adjustment" → "Image Stabilization" → "Initial-
Procedure
ize+Image Stabilization."
3. Press the Start key to start Stabilizer.
The Start key turns orange and stays lit up orange during the Stabilizer sequence.
4. Stabilizer is completed when the Start key turns green.
(6) Thin Paper Duplex Mode
Functions
• Turn this function ON when thin paper (64 g/m
perature and high humidity in the 2-sided mode.
• It decreases the transfer output value so as to prevent a paper misfeed from occur-
ring.
Use • Use when a paper misfeed occurs when thin paper is used.
Setting/ • The default setting is OFF.
Procedure
174
ON
Field Service Ver. 1.0 Mar. 2005
2
) is used in an ambience of high tem-
"OFF"