Mechanical Adjustment; Check/Adjustment Of The Punch Hole Positions; Checking The Punch Hole Position; Adjustment Of The Punch Hole Position - Konica Minolta bizhub C450 Service Manual

5. Mechanical adjustment

5. Mechanical adjustment
5.1

Check/Adjustment of the Punch Hole positions

5.1.1

Checking the punch hole position

5.1.2

Adjustment of the punch hole position

[1]
14
4683F3E507DA
[1]
4683F3C503DA
[2] [3]
4683F3C504DA
[1]
4683F3C503DA
Field Service Ver. 1.0 Mar. 2005
1. Load the Tray 1 with A4 paper.
2. Touch "Finishing" on Basic Screen.
3. Select Punch "2-Hole."
4. Place the A4 original (Blank paper
acceptable) on the original tray, and
press the Start key.
5. Fold the sample copy fed out of the
machine in half and check that the
punch holes are aligned with each
other.
Specifications: 0 ± 2 mm
6. If the specified range is not met,
adjust the punch hole position.
1. Open the upper cover [1], and loosen
the set screw for the Punch Hole
Guide Plate [2].
2. Move the green handle [3] back and
forth to adjust the punch holes.
3. Tighten the set screw [2].
4. Close the upper cover [1].
5. Make another sheet of sample copy
[1] to check that the punch holes are
aligned.
☞ 14