Konica Minolta bizhub C450 Service Manual page 760

Field Service Ver. 1.0 Mar. 2005
ON
1 2 3 4
NOTE
• The procedure must be carried out as specified. In particular, switching ON or OFF
must be performed properly.
• If a step or steps are wrongly performed in mid procedure, stop the procedure
immediately. Then, turn OFF and ON the Main Power Switch and start the proce-
dure over.
• This adjustment is applicable only to the punch position center adjustment. The
adjustment range is ± 5 mm. It does not adjust for variations in the punch hole
positions.
5 6 7 8
4583fs3530c0
16. Turn ON key 7 of SW1 of the Fin-
isher Control Board.
NOTES
• Flipping ON key 7 of SW1 validates
the setting made to the fixed sys-
tem based on the paper size as
changed from the lateral registra-
tion motion (automatic through end
face detection).
• To return the setting back to the lat-
eral registration motion, flip OFF
key 7 of SW1.
17. Turn ON the Main Power Switch of
the main unit.
18. Reinstall the rear cover.
☞ 2-7
6. Board switch
49