NEC Univerge SV8100 Features And Specifications Manual page 851

UNIVERGE SV8100
Flash
Pulse to Tone Conversion
Ring Groups
Speed Dial – System/Group/Station
Trunk Group Routing
Trunk Groups
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
14-01-01 Basic Trunk Data Setup – Trunk
Name
14-01-02 Basic Trunk Data Setup –
Transmit Level
14-01-08 Basic Trunk Data Setup – Toll
Restriction
14-02-01 Analog Trunk Data Setup –
Signaling Type (DP/DTMF)
14-02-02 Analog Trunk Data Setup – Ring
Detect Type
SV8100 Features and Specifications Manual
Description/Comments
Set the names for trunks. The trunk
name displays on a multiline
terminal for incoming and outgoing
calls.
Set these options for compatibility
with the connected PBX.
For each PBX trunk port, enable (0)
or disable (1) Toll Restriction.
At default, Program 14-02-01 is set
to 2 (DTMF).
This option sets Extended Ring
Detect or Immediate Ring Detect
for the trunk. For T1 loop/ground
start trunks, this option must be set
to 1 for the trunks to ring and light
correctly.
Assigned Data
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
0 = Restriction Disabled
(No)
1 = Restriction Enabled
(Yes)
(default = 1)
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
Trunks 1~200
0 = Normal/delayed
1 = Immediate Ringing
(default = 1)
Issue 1.0
Level
1 2 3
2 - 827