NEC Univerge SV8100 Features And Specifications Manual page 950

Issue 1.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-11-20 Service Code Setup (for Setup/
Entry Operation) – Change
Incoming CO and ICM Ring Tones
11-11-21 Service Code Setup (for Setup/
Entry Operation) – Check
Incoming Ring Tones
15-02-02 MultiLine Telephone Basic Data
Setup – Trunk Ring Tone
15-02-03 Multiline Telephone Basic Data
Setup – Extension Ring Tone
15-08-01 Incoming Virtual Extension Ring
Tone Setup
2 - 926
Description/Comments
If required, change the service code
used for changing the incoming ring
tones heard for CO and ICM calls.
If required, change the service code
used for checking how the incoming
ring tones sound.
Use this option to set the tone
(pitch) of the incoming trunk ring for
the extension port you are
programming.
Use this option to set the tone
(pitch) of the incoming extension
call ring for the extension port you
are programming. Also refer to
program 15-08.
When an extension or a virtual
extension is assigned to the
function key on the key telephone,
select the ring tone when receiving
a call on that key.
For ACD CAR keys, only tone
pattern 1 (entry 0) can be used. The
remaining patterns are not checked
with this feature.
UNIVERGE SV8100
Assigned Data
MLT
(default = 720)
MLT
(default = 711)
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 2)
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 8)
ICM Tone Pattern,
0 = Pattern 1
1 = Pattern 2
2 = Pattern 3
3 = Pattern 4
4 = Incoming Ring Tone
Extension
(default = 0)
Selectable Ring Tones
Level
1 2 3