Firmware Update Error - Ricoh D009 Service Manual

Updating the Firmware
Controller, engine and operation panel firmware cannot be updated at the
same time. It is recommended to update firmware modules one by one.
10. Touch "UpDate (#)" (or
While downloading is in progress, the LCD will display "Loading". When
downloading has been completed, the panel will display "update done".
For operation panel software, the Start key lights red while downloading is in
progress, and then lights green again after downloading is completed.
11. The "Update is Done" message appears on the operation panel after completing the
updating. The message differs depending on the firmware that has been updated.
12. Switch the copier main power switch off when you see the "Update is Done" message
or follow the procedure that is displayed on the operation panel.
13. Press in the SD card to release it. Then remove it from the slot.
14. Switch the copier on for normal operation.
15. Error Messages
An error message shows in the first line if an error occurs during the download.
The error code consists of the letter "E" and a number. The example above shows
error "E24" displayed. For details, refer to the Error Message Table. (
Firmware Update Errors" in this section)

Firmware Update Error

If a firmware update error occurs, this means the update was cancelled during the update
because the module selected for update was not on the SD card.
D009/D011/D012/D013/D091/D092
) to start the update.
5-16
"Handling
SM