Ricoh D009 Service Manual page 98

Punch Unit
9. Put the side-to-side detection unit [8] in the machine. Make sure that the two pins are
engaged correctly at the front.
10. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
11. Attach the side-to-side detection unit and connect it at the rear (
1).
12. Pull the short connector [9] out of the connector [10], then connect the cable [10] of the
finisher ( x 1).
This is the 3-pin connector.
13. At the front, use a pair of wire cutters to remove the part [11] of the cover.
14. Install the punch-waste transport unit [12] in the finisher.
15. Make sure that the punch-waste transport unit moves smoothly on its rails. If it does
not, make sure that the rails are aligned with the grooves.
16. Remove the short connector [13] from the connector [14].
D009/D011/D012/D013/D091/D092 2-52
x 2, x 1, x
SM