Touch Panel Position Adjustment - Ricoh D009 Service Manual

Scanner-2
pulley with the three windings must face the front of the machine. At the rear
of the machine, it must face the rear.
9. Perform steps 8 through 13 in "Reassembling the Front Scanner Wire".
After replacing the scanner wire, do the image adjustments in the following
section of the manual (

4.5.3 TOUCH PANEL POSITION ADJUSTMENT

It is necessary to calibrate touch panel at the following times:
When you replace the operation panel.
When you replace the controller board.
When the touch panel detection function does not operate correctly
Do not use items [2] to [9] on the Self-Diagnostic Menu. These items are for design use
only.
1. Press , press "1", "9", "9", "3", press
menu.
2. On the touch screen press "Touch Screen Adjust" (or press "1").
3. Use a pointed (not sharp) tool to press the upper left mark
4. Press the lower right mark when " " shows.
D009/D011/D012/D013/D091/D092
p.4-101).
5 times to open the Self-Diagnostics
4-24
.
SM