Updating Firmware; Preparation - Ricoh D009 Service Manual

5.4.2 UPDATING FIRMWARE

Preparation

1. If the SD card is blank, copy the entire "romdata" folder onto the SD card.
2. If the card already contains the "romdata" folder, copy the "D009" folder onto the card.
Do not put multiple machine firmware programs on the same SD card. Copy
the only model firmware you want.
1. Stop all SDK applications if the VM card is installed (
Unit").
2. Turn the main power switch off.
3. Remove the slot cover (
4. Remove the VM card from SD Card Slot 2 if it is installed.
5. Insert the SD card into SD Card Slot 2. Make sure the label on the SD card faces the
rear side of the machine.
6. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make
sure the SD card locks in place.
To remove the SD, push it in to unlock the spring lock. Then release it so it
pops out of the slot.
7. Disconnect the network cable from the copier if the machine is connected to a network.
8. Switch the main power switch on. After about 45 seconds, the initial version update
screen appears on the LCD in English.
9. On the screen, touch the button or press the corresponding number key on the
operation panel to select the item in the menu that you want to update.
ROM/NEW What it means
Tells you the number of the module and name of the version
ROM: currently installed. The first line is the module number, the second
line the version name.
Tells you the number of the module and name version on the SD
NEW: card. The first line is the module number, the second line the
version name.
SM
x 1).
5-15
Updating the Firmware
p.2-93 "HDD Encryption
D009/D011/D012/D013/D091/D092