Ricoh D009 Service Manual page 967

Printer Switch 01 [SP No. 1-103-002]
No FUNCTION
0-2 Not used
Maximum print width used in
the setup protocol
Bit 4: 0, Bit 3: 0 = Not used
3-4
Bit 4: 0, Bit 3: 1 = A3
Bit 4: 1, Bit 3: 0 = B4
Bit 4: 1, Bit 3: 1 = A4
5-6 Not used
Received message width
restriction in the protocol
7 signal to the sender
0: Disabled
1: Enabled
Printer Switch 02 [SP No. 1-103-003]
No FUNCTION
1st paper feed station usage
for fax printing
0
0: Enabled
1: Disabled
2nd paper feed station usage
for fax printing
1
0: Enabled
1: Disabled
SM
COMMENTS
Do not change the settings.
These bits are only effective when bit 7 of printer
switch 01 is "1".
Do not change the settings.
0: The machine informs the transmitting machine
of the print width depending on the paper size
available from the paper feed stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the
setup protocol (NSF/DIS).
1: The machine informs the transmitting machine
of the fixed paper width which is specified by bits 3
and 4 above.
COMMENTS
0: The paper feed station can be used to print fax
messages and reports.
1: The specified paper feed station will not be used
for printing fax messages and reports.
Do not disable usage for a paper feed
station which has been specified by User
Parameter Switch 0F (15), or which is
77
Bit Switches
D346