Ricoh D009 Service Manual page 908

Error Codes
Code Meaning
specified in CM/JM was
not available
(V.8 calling and called
terminal)
The calling terminal fell
back to T.30 mode,
0-74
because it could not detect
ANSam after sending CI.
The called terminal fell
back to T.30 mode,
0-75 because it could not detect
a CM in response to
ANSam (ANSam timeout).
The calling terminal fell
back to T.30 mode,
0-76 because it could not detect
a JM in response to CM
(CM timeout).
The called terminal fell
back to T.30 mode,
0-77 because it could not detect
a CJ in response to JM
(JM timeout).
The called terminal
0-79 detected CI while waiting
for a V.21 signal.
0-80 The line was disconnected
D346
Suggested Cause/Action
communication mode (e.g., the other terminal
was a V.34 data modem and not a fax
modem.)
A polling tx file was not ready at the other
terminal when polling rx was initiated from the
calling terminal.
The calling terminal could not detect ANSam
due to noise, etc.
ANSam was too short to detect.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
The terminal could not detect ANSam.
Check the line connection and condition.
Try receiving a call from another V.8/V.34 fax.
The called terminal could not detect a CM due
to noise, etc.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
The calling terminal could not detect a JM due
to noise, etc.
A network that has narrow bandwidth cannot
pass JM to the other end.
Check the line connection and condition.
Try receiving a call from another V.8/V.34 fax.
Check for line noise or other line problems.
If this error occurs, the called terminal falls
back to T.30 mode.
The guard timer expired while starting
18 SM