Jackshaft Bearing Greasing; Driveshaft Bearing Greasing - Polaris INDY TRAIL RMK Service Manual

MAINTENANCE / TUNE UP
Lubricate the following fittings with Polaris Premium All Season grease annually or approximately every 1000
miles (1600 km). Remove weight from the component being greased to permit better penetration and flushing
of the joint.
S Spindles, left and right.
S Rear suspension pivot shafts.
S Lubricate both front ski pivots at fitting as shown using
Polaris All Season grease.
S Grease jackshaft and driveshaft (clutch side) bearings.
S Use an aerosol lubricant on the steering post support
bracket.
S Grease steering post lower pivot.
S Grease center steering arm (bell crank), pitman arm, and
idler arm (where applicable).
NOTE: A grease gun kit complete with grease and adaptors is available to lubricate all fittings on Polaris snow-
mobiles.
0
0
0

Jackshaft Bearing Greasing

Loosen driven clutch retaining bolt and pull clutch outward to ex-
pose bearing. Use a point type grease gun fitting to inject grease
through hole in flangette into bearing until grease purges out in-
side or outside bearing seal. Push clutch back onto shaft and re-
place clutch retaining bolt.
Grease Gun Adapter: 2871174
Point Type

Driveshaft Bearing Greasing

Inject grease into fitting on speedometer drive adaptor until
grease purges out inside or outside bearing seal.
2.6
0
Aerosol
0
Polaris Premium All Season Grease
14 oz. PN 2871423
Grease Gun Kit PN 2871312
0
0
0
Jackshaft
Driveshaft
0
0
0