Front Torque Arm Limiter Strap Adjustment - Xtra-10 - Polaris INDY TRAIL RMK Service Manual

SUSPENSIONS
WARNING
Changing shock valving on models equipped with Ryde FXt or Foxt shocks requires special tools and a sound
knowledge of mechanical theory, tool use, and shop procedures in order to perform the work safely and correctly.
Shocks contain high pressure nitrogen gas. Extreme caution should be observed when handling and working
with high pressure service equipment. See Ryde FXt and Foxt Shock rebuilding information later in this chap-
ter.
Always verify ski alignment before making adjustments to the IFS. If the skis are misaligned, we recommend the
camber adjustment be checked as this may also be affected.

Front Torque Arm Limiter Strap Adjustment - XTRA-10

One method of changing ski-to-snow pressure is to change the
length of the front torque arm limiter straps. The limiter strap is
normally mounted in the fully extended position.
S Lengthening the straps decreases ski pressure under accelera-
tion.
S Shortening the straps increases ski pressure under acceleration.
To adjust models with quick adjust front limiter straps,turn the
eyebolt nut to lengthen or shorten the straps. To shorten the
strap, turn the nut clockwise. To lengthen the strap, turn the nut
counterclockwise.
NOTE:Both limiter straps must be adjusted evenly and remain
equal in length to avoid improper Hi-Fax and track wear.
7.18
Turn nut to adjust
Turning clockwise shortens strap.
Turning counterclockwise lengthens
strap.