Polaris INDY TRAIL RMK Service Manual page 173

FUEL SYSTEM / CARBURETION
WARNING
Fuel spillage will occur during this installation. Gasoline is extremely flammable and explosive under certain
conditions.
Do not smoke or allow open flames or sparks in or near the area where refueling is performed or where
gasoline is stored.
Do not weld or operate a torch near the fuel system. Remove fuel tank before any chassis welding is per-
formed.
If you get gasoline in your eyes or if you swallow gasoline, see your doctor immediately.
If you spill gasoline on your skin or clothing, immediately wash it off with soap and water and change clothing.
Never start the engine or let it run in an enclosed area. Gasoline powered engine exhaust fumes are poison-
ous and can cause loss of consciousness and death in a short time.
1. Turn fuel valve off.
2. Remove air silencer.
3. Position a shop cloth or container below drain
plug and water trap plug.
4. Remove drain plug and sealing O-Ring, or slide
clamp upward and remove water trap plug.
5. Drain water/fuel.
contact cleaner and dry with compressed air.
6. Lightly grease O-ring and install water trap
assembly into bottom of float bowl, or reinstall
trap plug in hose and position. Tighten securely.
7. Turn fuel on, start engine and check for possible
fuel leaks.
8. Reinstall air box.
The water traps should be periodically inspected and
drained. Draining frequency will depend upon fuel
supply, riding conditions, and fuel handling precau-
tions.
4.34
Clean trap with electrical
Float
Bowl
Drain Plug
Clamp
O-Ring
Hose
Water Trap
Plug