Track Installation - Polaris INDY TRAIL RMK Service Manual

BRAKES / FINAL DRIVE

Track Installation

1. Tip machine back onto left side. Insert suspension,
rear first, into the track.
2. Move the suspension back and forth until front
torque arm mounting bolts can be started. Tighten
finger tight.
3. Rotate the suspension until the rear mount bolts can
be installed in the same manner as the front.
NOTE: For ease of installation, turn the front rear scis-
sor stops (FRSS) to low position. This allows the rear
torque arm to move forward more to line up holes.
4. Torque suspension mounting bolts to specification.
5. Return front rear scissor stops (FRSS) to original
position.
6. Install suspension springs.
7. Align track (outlined in suspension section) and
tighten adjuster and rear shaft bolts to specification.
3/8² Suspension Bolt Torque -
35-40 ft. lbs (48.3-55.2 Nm)
7/16² Suspension Bolt Torque -
45-50 ft. lbs. (62.1-69 Nm)
8.32
FRSS (Front Rear Scissor Stop)
XTRA-10 Shown