Polaris INDY TRAIL RMK Service Manual page 356

Multimeter Usage
A - - - = Amps DC - used to check battery charge rate, system draws, etc.
Used to check the current flow to and from the battery.
Test Method
1. Make sure red lead is in the 10A terminal of the meter and the black lead is in the Com (--) terminal of the meter.
2. Disconnect battery ground wire(s) from battery (--) terminal.
3. Connect red meter lead to battery (--) terminal.
4. Connect black meter lead to harness ground wires and cable.
CAUTION:
Do not operate electric starter (if equipped) or meter damage may occur.
Usage
Testing key off current draw
S
Testing key on current draw
S
Testing charging system break even RPM
S
Testing DC current flow (direction), is battery charging?
S
NOTE: When using the DC Amp settings, the red test lead must be moved to the 10A socket on the front of the
instrument.
ELECTRICAL
9.3