Polaris INDY TRAIL RMK Service Manual page 289

SUSPENSIONS
Foxä Shock Maintenance
Disassembly, Cont.
5. If body of shock starts to unscrew from body, tighten
and try again. To keep body from turning, it may be
necessary to use Body Clamp Tool clamped lightly
around body in soft jaws of vise as shown.
NOTE:Position body clamp at least 1 1/2² below bearing
cap.
Shock Body Clamp Tool
PN 2871071
6. Pull shock rod and piston straight out to avoid seal or
valve damage. Be prepared to catch piston ring
when removing the damper rod/valve piston.
7. Remove shock from vise and dispose of used oil
properly in suitable container. Set shock body aside.
8. Mount damper rod in soft-jawed vise. Loosen valve
nut and clean the valve piston and valving washers
with electrical contact cleaner. Dry thoroughly with
compressed air. Tighten nut and torque to 12 ft. lbs.
(17 Nm).
Valve Nut Torque -
12 ft. lbs. (17 Nm)
7.28