Handlebar Torque And Sequence - Polaris INDY TRAIL RMK Service Manual

Handlebar Torque and Sequence

1. Remove handlebar cover.
2. Using a 7/16² (11 mm) wrench, loosen four nuts on
bottom of adjuster block. NOTE: Turn handlebar to
left or right for access to back nuts.
3. Adjust handlebar to the desired height. Be sure that
handlebars, brake lever and throttle lever operate
smoothly and do not hit the fuel tank, windshield or
any other part of the machine when turned fully to
the left or right.
IMPORTANT: When adjusting the handlebar, be sure
the serrations in handlebar and adjuster block match be-
fore torquing.
4. Torque the handlebar adjuster block bolts to
specification following sequence shown. The gap
should be equal at front and rear.
Handlebar Adjuster Block Bolt Torque -
11-13 ft. lbs. (15 - 18 Nm)
5. Replace handlebar cover.
BODY AND STEERING
Socket Screws
2
3
1
4
6.25